How to setup kozumi KTV-01C (chip bt878 rev11)

I have setup this card with gentoo 2008. In some others distributions like Ubuntu or Fedora, I’m sure it should be easier.

The card that I’m writing about is:

It works with module bt878

make && make modules_install

after that we edit /etc/modprobe.conf or /etc/modprobe.d/bttv and we add the following lines:

Now we can try the card with:

We can check if they loaded successfully:

# dmesg | grep tuner
bttv0: tuner type=38
tuner’ 0-0060: chip found @ 0xc0 (bt878 #0 [sw])
tuner-simple 0-0060: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))

Install tvtime:

You should set it to the norm of you country, I set it to PAL-Nc:

And if everything went well, we should see something like this:

Last, but not least, we have to add to /etc/modules.autoload.d/kernel-2.6 tuner:

Remote Control

In order to setup the remote control you have to edit a few lines in the kernel module. We are going to edit $source/drivers/media/common/ir-keymaps.c:

Anf where it says IR_KEYTAB_TYPE we remove all the keys and we leave it like this:

EXPORT_SYMBOL_GPL(ir_codes_pixelview);

Then, in the kernel source directory, we run:

make && make modules_install y listo.

I got some hints from:

http://www.linuxforums.org/forum/peripherals-hardware/91984-remote-controller-bt878-kozumi-ktv-01c.html